Doc's Clip-N-Go Assembly Instructions
Step 1: Check
the dimensions of the product.
Step 2: Cut the
end of the hose in a perpendicular
direction, using the manual cutter.
Step 3: Place the double clamp on the flexible hose in
such a way that the tooth of bar A comes
contact with the end of the hose that has been
cut.
Step 4: Lubricate the end of the coupling joint with the
same oil used in the air conditioning system.
Step 5: Find the correct orientation and insert completely
the fitting into the hose.
Step 6: A = round nose, B = thin nose
Step 7, 8, 9: To fit the coupling in place, position the
round nose of the pliers (A) at the hook shaped
end of the clamp and the thin nose (B) at
the end with the hooked teeth. Tighten the
double clamp until the click using the special
"CLIC" open-close pliers. To disassemble, just
reverse the position of the ends of the pliers
on the clamp.
|
